Installation Instructions ( o0 ,0uod)
STEP 5
Light the Pilots
(for models equipped with standing pilots)
The range should be installed in its permanent position before any pilots are lit or adjusted.
Hght the Surface Burner Pilots
CAWHON: Make sure the surface burner control lmobs are in the OFF position before attempting to light the pilots,
1.Raise the cooktop.
2.Hght both pilots with a match.
3.To avoid pilot outage, use caution when dosing cooktop after lighting pilots.
NOTE: Do not leave standing pilot lit in a newly
constructed or remodeled home or apartment that will
be unoccupied for more than a month°
Adjust the Surface Burner
Pilots If Necessary
1.Raise the cooktop°
2.Locate the pilot adjustment screw. It can be accessed through the small hole near the center of the manifold panel
3.To adjust, use a blade- type screwdriver with a shaft diameter of less than 3/t 6"
(5 mm). Turn pilot
adjustment screw until pilot is 5/16"
(8 mm) high. Do not
reduce the flame to less than 5/16" (8 mm) or pilot outage may occur. A pilot flame burning higher
than recommended may generate soot (carbon black) on the bottom of your cooktop_
Each pilot flame was adjusted at the factory to be
approximately 5/16" (8 ram) tall A tinge of yellow appearing at the upper tip is normal. If you find pilot
adjustment is necessary, follow instructions at right.
Hght the Oven Pilot
CAUTION: Make sure the OVEN CONTROL knob
is in the OFF position before attempting to light the pilot.
1.Remove the broiler drawer by sliding the drawer all
the way out and then lifting slightly to remove it from its tracks.
2.Locate the pilot at the back of the broiler compartment. The pilot is attached to the left side of the oven burner.
3w Light the pilot with a match. No adjustments are required for natural gas. If range is connected to LP gas, contact the person who installed your range or made the conversiom
36
