If your TV has A/V input jacks, you may connect your
VCR's AUDIO/VIDEO OUTPUT jacks to the audio/video input jacks on back of your TV.
Direct audio/video connections usually result in a better picture and sound quality for tape playback. Please see your TV's owner's manual for details.
Then, set your TV to the Video mode using TV/VCR button on your "IV.
[Back of the unit}
_lr oAUDIO0
l- ov,0 oe
ideo "Y_'_
,.v.+,,,00,
++, II°o
9oo,9
TO COPY A VIDEO TAPE
Connect the editing (recording) VCR, the source (playing) VCR and your TV using the following diagram.
NOTE: You can use the audio and video input jacks on the front panel at editing(recording) VCR instead of using acks on the back.
Main Unit |
| +o |
|
[Editing(Recording)VCR] |
| U_s set] | |
|
| e for monitoring) | |
|
|
| |
* | Coaxial cable (supplied) | ,0 Antenna input jack |
|
|
|
|
AudioNideoadaptercord
(not supplied)
[Source (Playing) VCR] r_ _ _ oEo?_o_O
31
1.Insert a
2.Insert a blank video cassette, or one you want to re- cord over, into the editing(recording) VCR cassette compartment.
3.Press SPEED button on the editing(recording) VCR to select the desired recording speed (SLP, LP or
SP).
4.Select L I or L2 position on the editing(recording) VCR. See page 13, under "Input Select".
5.Press REC button on the editing(recording) VCR.
6.Begin playback of the tape in the source(playing) VCR.
NOTE: For best results during dubbing, use the VCR's front panel controls whenever possible. The remote control might affect the playback VCR's operation.
•Always use
•You can use a video disc player, satellite receiver, or other audio/video component with A/V outputs in place of the source(playing) VCR.
TO MONITOR THE RECORDING
!.Turn on the TV and set it to the same output channel as the editing(recording) VCR channel 3 or 4.
2.Press TV/VCR button on the editing(recording) VCR so that "VCR" appears on the display.
EN |
