If yourcable service supplies you with acable converter box, you can usethe basic connection shown below.

TO RECORD AND VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL.

I. Press TV/VCR button sothat "VCR" appearson the
display.
2. Set the TV channel to the same video output channel
as the switch located on the back of the VCR (CH3
or 4).
3. Set the VCR channel selector to the output channel
of the Cable Converter box. (EXAMPLE CH3)
4. Select the channel to be recorded at the Cable Con-
verter Box.
NOTES:
•With this connection, you CANNOT record one
program while viewing another.
•Channel memory programming is NOTneeded when
using this connection.
CableTV ToVCR'sANT,IN Terminal
ConvenerBox I
:::i-i'.illl
/ / _Jack
CATV(Cable) ToVCR'sANT.OUTTerminal
Input
CONTROLLING VCR INPUT & OUTPUT
When the VCR isin the Playback mtxie,or whenthe TV/VCR button isin the VCR position,
your TV will receive the signals from the VCR on either channel 3 or 4. Set the 3CH/4CH
selector switchto the station thatis not used for normalbroadcasts in yourarea; then set your CH3 CH4
TV to that same channel when viewing from theVCR.
The video output channel of this unit is set to channel 3 prior to shipment from the factory.
To use the external input jacks, select the "LI" or "L2" position.
• If you usethe audio and video inputjacks on the back of the unit, press 0, 0, I with number buttons to select
the "LI" position.
• If you use the audio and video input jacks on the front of the unit, press 0, 0, 2 with number buttons to select
the '%2" position.
You can select "LI", '%2" as a channel by using the CHANNEL "A" or "V" button.
Note: "I.,1" and "I.,2" are found before the lowest memorized channel. (Example: CH2)
[vdII) _Ol_V_[0]|] N_NmKN H[0]_1 [0]_1MIk"i
TV power must be on. Please see your TV's owner's manual/or details.
To Set TV tothe Video Mode
your
Connection Using AV Cord Setyour TV to the Video mode using TV/VCR buttonof your 'IV.
(Refer to page 12.) To set your TV to the TV mode, press TV/VCR button of your TV again.
Connection Without AVCord Set theTV channel to the same video outputchannel located on the back of the VCR.
(Refer topage 10, I i, 13.) (CH 3 or4) Then, set your VCR to the VCR mode using TV/VCR button of your VCR.
- 13- EN
***** 5C16