Introduction

The click history is only recorded for the current session, i. e. until you log out. After logging in for a new session, the recording of tabs and paths will start all over again.

Information Update

Some parts of the information that is provided on the tabs of the Web interface will change from time to time. In these cases, the information display is updated automatically every three seconds by Webwasher.

So, e. g. you might have performed a manual update of the anti-virus engines. This means that the information provided in the Current Status and Log File Content sections on the corresponding AV Engine tab will begin to change

continuously over a certain period of time until the update is completed.

These sections are then updated automatically every three seconds to reflect the status of the update process.

Logout

To logout from a Webwasher session, click on the logout link, which is located in middle position at the top of the Web interface area.

After logging out, the login page is displayed, where you can login again and start a new session.

Main Feature Enabling

There are Webwasher settings that cannot only be modified if a corresponding

main feature is disabled. So, e. g. if you want to modify the settings of the Phishing Filter section on the Settings tab under Anti-Spam > Message Filters, you need to make sure the Message Filter feature itself is also en-

abled.

If you attempt to modify settings while the corresponding main feature is not enabled, an alert is displayed to make you aware of this situation:

1–9