Sharp AL-1650 operation manual Copier TROUBLE?, Self-diagnostic function, Example

COPIER TROUBLE?

Problem

Solution

Power is on but copying is not possible.

Lighting fixture flickers.

●Is the POWER SAVE ( ) indicator blinking?

●Is the indicator on?

●Is blinking in the copy quantity display?

●Is steadily lit in the copy quantity display?

●Is the indicator blinking?

●Is the indicator blinking?

●Is the START key ( ) indicator blinking?

●Is the same power outlet used for the lighting fixture and the copier?

Wait until warm-up is complete.

Warm-up time is approximately 35 seconds.

Copy paper is needed. See page 13, LOADING COPY PAPER.

The TD cartridge is not installed. Install the TD cartridge.

Side cover is open.

Close the front and side covers securely.

The TD cartridge must be replaced. See page

32, TD CARTRIDGE REPLACEMENT.

A misfeed has occurred. See page 36,

MISFEED REMOVAL.

Toner replenishment takes up to 2 minutes.

Wait until the START key ( ) indicator stops blinking.

Connect the copier to a power outlet which is not used for other electric appliances.

Copier trouble?

Be sure to use only genuine SHARP parts and supplies.

Please contact your SHARP service center immediately if a problem persists after checking the above.

Self-diagnostic function

An automatic self-diagnostic function is built into the copier. Should the copier malfunction, the self-diagnostic function will locate the problem and stop the copier to prevent damage. An alphanumeric code will appear in the copy quantity display.

Example

Should the copier completely stop and a letter and a number appear alternately, contact your SHARP service center immediately.

GENERAL INFORMATION

49