Sharp AL-1670 operation manual Normal Copying, Using the SPF, Turn the power switch on

Adjust the copy density.

● This copier has three exposure modes to choose from — AUTOMATIC

( ), MANUAL ( ), and PHOTO ( ).

● Automatic exposure is the standard initial setting for this copier. In this mode, the characteristics of the original are “read” by the exposure system and adjustments are automatically made. This optimizes the contrast of the copied images by reducing the effect of colored or shaded background areas. See page 28 to adjust the automatic exposure level.

Adjust the original guides to the size of the originals.

NORMAL COPYING

This copier has two document input stations — a single pass feeder (SPF) for automatic document feeding and an original table for manual handling of bound documents. The SPF is designed to hold up to 30 originals measuring from 5-1/2" x 8-1/2" to 11" x 17" and in the weight range of 15 to 24 lbs.

●Before loading originals into the SPF, be sure to remove any staples or paper clips from them.

●Damaged or crumpled originals may misfeed in the SPF. It is recommended that these originals be copied from the original table.

●Special originals such as transparency film and tracing paper should not be fed from the SPF, but should be placed directly on the original table.

●Image loss (max. 5/32" (4 mm)) can occur at the leading edge of the copies. It can be 15/64" (6 mm) at the trailing edge of the copies which are made using the SPF. Also image loss (max. 5/32" (4 mm) in total) can occur along the other edges of the copies.

MAKING COPIES Normal copying

Using the SPF

Turn the power switch on.

Power on	1	●	It will take about 35 seconds for the copier to warm up.
			However, you can make desired settings and press the START (	)
			key during warm-up. Copying will start after warm-up.

●If the power is already on and all indicators except the POWER SAVE

indicator are off, the copier is in the auto power shut-off mode. Press the START key in this case. See page 52, POWER SAVE MODES.

2 Ensure that no original is left on the original table.

3

4	Set the originals face up in the document feeder tray.
	● The SPF indicator will light up. If this indicator does not light up, the
	originals are not properly set or the SPF is not properly closed.
	● The ORIGINAL SIZE indicator for the detected original size will light
	up, and the paper tray with the corresponding paper size will be
	automatically selected if that paper size is available.
	● The auto paper select function can be disabled using user program No.
	8. If this function has been disabled, use the TRAY SELECT (	)
	key to select the desired paper tray. See page 49, USER PROGRAMS.
	● To copy onto a different size paper, use the TRAY SELECT (	) key
	to make the selection.
	● The bypass tray cannot be automatically selected.

5

16