Sharp AL-1670 operation manual Copier TROUBLE?, Self-diagnostic function, Example

COPIER TROUBLE?

Problem

Solution

Power is on but copying is not possible.

●Is the POWER SAVE ( ) indicator blinking?

●Is the indicator on?

●Is blinking in the copy quantity display?

●Is steadily lit in the copy quantity display?

●Is the indicator blinking?

●Is the indicator blinking?

Wait until warm-up is complete.

Warm-up time is approximately 35 seconds.

Copy paper is needed. See page 13, LOADING COPY PAPER.

The TD cartridge is not installed. Install the TD cartridge.

Side cover(s) is open.

Close the front and side covers securely.

The TD cartridge must be replaced. See page

39, TD CARTRIDGE REPLACEMENT.

A misfeed has occurred. See page 43,

MISFEED REMOVAL.

Lighting fixture flickers.

● Is the same power outlet used for	Connect the copier to a power outlet which is
the lighting fixture and the copier?	not used for other electric appliances.

Be sure to use only genuine SHARP parts and supplies.

Please contact your SHARP service center immediately if a problem persists after checking the above.

Self-diagnostic function	Copier trouble?
An automatic self-diagnostic function is built into the copier. Should the
copier malfunction, the self-diagnostic function will locate the problem and	GENERAL
stop the copier to prevent damage. An alphanumeric code will appear in the
copy quantity display.
Example	INFORMATION
Should the copier completely stop and a letter and a number appear alternately,

contact your SHARP service center immediately.

57