Sharp AR-C260, AR-C260M NOTE, NOTE, NOTE, CAUTION, CAUTION, CAUTION, Exit area, Fusing area, Transport area, MISFEED REMOVAL, Upper exit tray:, Models without the

MISFEED REMOVAL

Misfeed in the transport area, fusing area, and exit area

Transport area1 Open the upper side cover and check for a misfeed.

Grasp the finger hold and gently open the cover.

NOTE

If paper is loaded in the bypass tray, temporarily remove the paper and close the bypass tray before opening the side cover.

Be careful not to tear the misfed paper during removal.

NOTE

The misfeed may have occurred inside the machine. Check carefully and remove it.

2 Gently close the upper side cover.

NOTE

Even after clearing a misfeed, paper may remain inside the machine on the transfer belt where it is not visible. In this case, after visible misfeeds are removed, the paper on the transfer belt will be automatically moved to a position where it is visible and a misfeed will be indicated once again on the display. Clear the misfeed as explained in "Misfeed in the transfer unit" (step 3 on the right side of this page). For this reason, it may be necessary to perform the "Misfeed in the transfer unit" procedure twice.

Fusing area1 Open the duplex bypass/inverter unit.

Grasp the finger hold and gently open the unit.

2 Remove the misfed paper as shown in the illustrations below.

If paper is misfed in the transport area, turn roller rotating knob A in the

direction of the arrow to remove the misfed paper.

CAUTION

The fusing unit is hot. Take care in removing paper. (Do not touch any metal parts.)

If you do not find a misfeed, open the cover of the fusing unit and check for a misfeed inside the fusing unit.

CAUTION

The fusing unit is hot. Take care in removing paper. (Do not touch any metal parts.)

Exit area1 Misfeed in the exit areaModels with an exit tray attached to the duplex bypass/inverter unit:

Gently remove the misfed paper as shown in the illustration, taking care not to tear the paper.

Models without theduplex bypass/ inverter unit:

Gently remove the misfed paper as shown in the illustration, taking care not to tear the paper.

Upper exit tray:

Gently remove the misfed paper as shown in the illustration, taking care not to tear the paper.

3 Misfeed in the transfer unit

If paper is misfed on the transfer belt, remove it gently without touching the transfer belt. Do not pull out the transfer unit.

CAUTION

The transfer unit is hot. Take care in removing paper. (Do not touch any metal parts.)

4 Gently close the duplex bypass/inverter unit.

After closing, confirm that the misfeed message has been cleared and the normal display appears. If the duplex bypass/ inverter unit is not installed, close the side cover in the same way.

2-20