5
KEY OPERATOR PROGRAMS
The key operator programs allow the administrator of the machine (key operator) to enable and disable functions to suit the needs of the workplace. This chapter explains the key operator programs for the network and printer functions. For key operator programs for general use of the machine, see the "Key operator's guide".
For the initial key operator code set at the factory, see "PROGRAMMING A KEY OPERATOR CODE" in the "Key operator's guide".
KEY OPERATOR PROGRAM LIST
The key operator programs for the network and printer functions are shown in the following table. Factory default settings are indicated in bold. When "YES, NO" appears in the "Settings" column of a program, the program is enabled by pressing the [OK] key so that a checkmark appears in the checkbox. A checkmark in the checkbox ( 
) indicates that "YES" is selected. No checkmark ( 
) indicates that "NO" is selected.
Note | The key operator programs that can be accessed depend on the machine and the options that are installed. | |||
|
|
|
|
|
|
|
|
|
|
Mode |
| Program | Settings | Explanation |
|
|
|
|
|
NETWORK |
| ENABLE DHCP | YES, NO | Enable this setting if the machine will use an |
|
|
|
| IP address that is assigned by a DHCP server. |
|
|
|
| If DHCP is used, the IP address assigned to |
|
|
|
| the machine may change automatically on |
|
|
|
| occasion. If this happens, printing will not be |
|
|
|
| possible. Change the port setting of the printer |
|
|
|
| driver to the new IP address. |
|
|
|
|
|
|
| IP ADDRESS SETTINGS | – | If the machine will be assigned a permanent |
|
| • IP ADDRESS |
| IP address, use these settings to enter the IP |
|
| • SUBNETMASK |
| address, subnet mask, and default gateway. |
|
| • DEFAULT GATEWAY |
| ☞ SPECIAL SETTINGS (page 33) |
|
|
|
|
|
|
| ENABLE TCP/IP | YES, NO | Select whether or not TCP/IP protocol will be used. |
|
|
|
|
|
|
| ENABLE NetWare | YES, NO | Select whether or not NetWare protocol will |
|
|
|
| be used. |
|
|
|
|
|
|
| ENABLE EtherTalk | YES, NO | Select whether or not EtherTalk protocol will |
|
|
|
| be used. |
|
|
|
|
|
|
| ENABLE NetBEUI | YES, NO | Select whether or not NetBEUI protocol will |
|
|
|
| be used. |
|
|
|
|
|
PRINTER |
| NOTICE PAGE | YES, NO | Select whether or not a Notice Page (page |
|
|
|
| 36) is printed when printing is not successful |
|
|
|
| due to a memory full (or other) error. |
|
|
|
|
|
|
| FORCED OUTPUT OF | YES, NO | When no tray has the specified size of paper, |
|
|
| this setting is used to select whether or not | |
|
|
|
| the print job will be printed on the closest size |
|
|
|
| of paper. |
|
|
|
|
|
|
| OUTPUT TRAYS | CENTER TRAY, | Specifies the output tray. When the printer |
|
|
| UPPER TRAY | driver is used to print, the setting in the printer |
|
|
|
| driver has priority. (This setting is only |
|
|
|
| available if a job separator tray is installed.) |
|
|
|
|
|
31
