Sharp LC-46PD7X operation manual Attaching the stand, Preparation

Preparation

Attaching the stand

•Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.

•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.

CAUTION

•Attach the stand in the correct direction.

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

1	Confi rm the 10 screws supplied with the TV.		3	1 Insert the stand into the openings on the
	Short screws (g6)	Long screws (g4)		bottom of the TV.
				2 Insert and tighten the 4 long screws into
	(used in step 2)	(used in step 3)
				the 4 holes on the rear of the TV.
					Hex key
2	Attach the two supporting post for the stand			2	Long screw 2
	unit onto the base using the box for the stand
	unit as shown below.
	(Close-up of the upper side of the stand unit)
					Soft cushion

23

	1
3	Hex key
	2
1

Short screw

1Insert each of the protrusions on the two supporting posts into the openings on the upper side of the base.

2Insert and tighten the 6 short screws with

the hex key (supplied with the product) in the order of 1, 2 and 3.

1

NOTE

• To detach the stand, perform the steps in reverse order.

6