Mounting Options
■Please use an optional table stand or
Mounting | This monitor is equipped with a temporary stand when shipped from the factory. Please | |
note this stand is for temporary use only until the monitor is properly mounted. Be sure to | ||
precautions | ||
use a | ||
| optional). |
Mounting the table stand (AN-37ST1) (LC-M3700)
See the table stand instructions for details.
M5 screws 25 mm length | 1. Assemble the table stand. |
(5 screws) |
|
| ● Align the 5 screw holes of the stand base with |
| the corresponding screw holes of the stand |
| hinge. Then attach the stand base to the stand |
| hinge using the supplied 5 screws (M5 25 mm |
| length). |
Stand base |
|
Stand hinge
2. Detach the temporary stand.
Terminal cover
ConnectionInstallation and
Wide LCD Monitor
Temporary stand
Table
Soft cloth, etc.
M5 screws 12 mm length (4 screws)
●Place the monitor (face down) on a table, etc. covered by a thick, soft cloth for LCD panel protection.
●Position the monitor near the edge of the table so that the temporary stand does not hit the table, then remove the terminal cover.
●Unfasten the 4 screws used to secure the temporary stand in place, then remove the stand.
3.Attach the table stand assembled in step 1 to the back of the monitor using the supplied 4 screws (M5 12 mm length).
●After installation, close the terminal cover, and adjust the monitor to a suitable angle. (Tilting range: up to 4˚ forward and 6˚ backward. Rotating range: up to 10˚ clockwise and anticlockwise.)
Table stand