Mounting Options (Continued)

Setting the angle of the wall-mount bracket

■The wall-mount bracket is assembled for perpendicular installation, so to use it for tilted installation, please follow the procedure below to set it at the installation angle.

Setting the installation angle.

1Remove the 2 vertical installation screws. These screws are used when setting the angle in step 3.

2Assemble the wall-mount bracket as desired as shown in the figure. (Figure shows a 20˚ angle.)

3Use the screws removed in Step 1 (M6 15 mm length ⋅ 2 screws) and the included screws M6 15 mm length ⋅ 2 screws to loosely fasten the angle-setup bracket with 4 screws. Firmly tighten these 4 screws after the angle-setup bracket position has been determined.

Wall-mount bracket

 

• When setting the angle of the wall-mount bracket,

Caution

be careful not to pinch your fingers, etc.

ConnectionInstallation and

Installation angle:

LC-M3700

(Horizontal mount)

0° to 20°

 

 

 

LC-M3710

(Vertical mount)

0°

 

 

 

Screws M6 15mm length (4 screws) As the screw hole numbers become larger (5, 10,15, 20), the Wide LCD Monitor will be tipped farther forward.

 

˚

10˚

5˚

 

 

˚

15

 

 

20

 

 

 

Install so that the angle-setup bracket spacers are facing inward.

Wall-mount bracket

Angle setup bracket (2 units)

Attaching wall-mount bracket to the monitor

 

Screws

Terminal cover

(4 locations)

 

Wide LCD Monitor

Temporary stand

Table

1.Detach the temporary stand.

●Place the monitor (face down) on a table, etc. covered by a thick, soft cloth for LCD panel protection.

●Position the monitor near the edge of the table so that the temporary stand does not hit the table, then remove the terminal cover.

●Unfasten the 4 screws used to secure the temporary stand in place.

Soft cloth, etc.

25 US