2Press ', ", \ and to adjust the Keystone Correction.
•You can also adjust the Keystone Cor-
rection using the 
, 
, 
and 
buttons on the projector.
Note
•Press 
to return to the default setting.
•Straight lines or the edges of images may appear jagged while adjusting the image.
3 Press 
.
•The
•You can also use 
on the projector. 
Note
•You can use the same settings used in NORMAL mode 4:3 for 16:9.
Turning the Power off (Putting
the Projector into the Standby Mode)
1Press 
on the projector or
STANDBY
on the remote control, then press that button again while the confirmation message is dis- played, to put the projector into the standby mode.
Note
•If you accidentally pressed 
STANDBY
or 
and do not want to put the pro-
jector into the standby mode, wait until the confirmation message disappears.
2Unplug the power cord from the AC outlet after the cooling fan stops.
Info
•Do not unplug the power cord during pro- jection or cooling fan operation. The cool- ing fan in this projector continues to run for about 90 seconds after the projector enters the standby mode. This can cause damage due to rise in internal tempera- ture, as the cooling fan also stops.
Compresses upper side.
Compresses lower side.
STANDBY button
Projection
-21
