Sharp PG-B10S Projecting a Reversed Image, Projection from behind the Screen, Ceiling-mount Setup

Setting up the Screen

Projecting a Reversed Image

Projection from behind the Screen

■Place a translucent screen between the projector and the audience.

■Reverse the image by setting “Rear” in the “PRJ Mode” menu. (See page 49.)

Translucent screen

Audience

Projection Using a Mirror

■Place a mirror (normal flat type) in front of the lens.

■When the translucent screen is placed on between the mir- ror and audience, set to “Front” in the “PRJ Mode” menu. (See page 49.)

■When the mirror is placed on the audience side, set to “Rear” in the “PRJ Mode” menu. (See page 49.)

Set to “Front”	Set to “Rear”
	Mirror

Audience	Translucent screen
	Audience

Mirror

Info

•When using a mirror, be sure to carefully position both the projector and the mirror so the light does not shine into the eyes of the audience.

Ceiling-mount Setup

■It is recommended that you use the optional Sharp ceiling- mount bracket for this installation.

Before mounting the projector, contact your nearest Sharp Authorized Projector Dealer or Service Center to obtain the recommended ceiling-mount bracket (sold separately).

•AN-B10T ceiling-mount bracket, its AN-TK201 and AN-TK202 extension tubes (for countries other than the U.S.A.).

■Be sure to adjust the position of the projector to match the distance (H) from the lens center position (see page 57) to the lower edge of the image, when mounting the projector on the ceiling.

■Do not mount the projector upside down.

When the image is projected from behind the screen using the default setting.

▼On-screen Display

Set to “Rear”.

▼On-screen Display

The image is reversed.

-58