WARNING:

The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode. During normal operation, when putting the projector into the standby mode always use the STANDBY button on the projector or on the remote control. Ensure the cooling fan has stopped before disconnecting the power cord.

DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.

PRODUCT DISPOSAL

This projector utilizes tin-lead solder, and a pressurized lamp containing a small amount of mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or, if you are located in the United States of America, the Electronic Industries Alliance: www.eiae.org .

Caution Concerning Lamp Replacement

See “Replacing the Lamp” on page 65.

LAMP REPLACEMENT CAUTION

BEFORE REMOVING THE SCREW, DISCONNECT POWER

CORD. HOT SURFACE INSIDE. ALLOW 1 HOUR TO COOL

BEFORE REPLACING THE LAMP. REPLACE WITH SAME

SHARP LAMP UNIT TYPE BQC-PGB10S//1 ONLY.

UV RADIATION : CAN CAUSE EYE DAMAGE. TURN OFF

LAMP BEFORE SERVICING.

HIGH PRESSURE LAMP : RISK OF EXPLOSION. POTENTIAL

HAZARD OF GLASS PARTICLES IF LAMP HAS RUPTURED.

HANDLE WITH CARE. SEE OPERATION MANUAL.

PRECAUTIONS A OBSERVER LORS

DU REMPLACEMENT DE LA LAMPE.

DEBRANCHER LE CORDON D’ALIMENTATION AVANT DE

RETIRER LA VIS. L’INTERIEUR DU BOITIER ETANT

EXTREMEMENT CHAUD, ATTENDRE 1 HEURE AVANT DE

PROCEDER AU REMPLACEMENT DE LA LAMPE.

NE REMPLACER QUE PAR UNE LAMPE SHARP DE TYPE

BQC-PGB10S//1.

RAYONS ULTRAVIOLETS : PEUVENT ENDOMMAGER LES

YEUX. ETEINDRE LA LAMPE AVANT DE PROCEDER

A L’ENTRETIEN.

LAMPE A HAUTE PRESSION : RISQUE D’EXPLOSION.

DANGER POTENTIEL DE PARTICULES DE VERRE EN CAS

D’ECLATEMENT DE LA LAMPE. A MANIPULER AVEC

PRECAUTION, SE REPORTER AU MODE D’EMPLOI.

This SHARP projector uses an LCD (Liquid Crystal Display) panel. This very sophisticated panel contains 480,000 pixels (RGB) TFTs (Thin Film Transistors). As with any high technology electronic equipment such as large screen TVs, video systems and video cameras, there are certain acceptable tolerances that the equipment must conform to.

This unit has some inactive pixels within acceptable tolerances which may result in inactive dots on the picture screen. This will not affect the picture quality or the life expectancy of the unit.

When Attaching the “QUICK GUIDE” Label

Attaching the “QUICK GUIDE” Label (supplied) on the projector will help you check the setup procedure. Be sure to attach the “QUICK GUIDE” Label on the top cabinet of the projector as shown in the drawing on the right. Do not attach the “QUICK GUIDE” Label anywhere else to avoid blocking an air intake or exhaust vent.

“QUICK GUIDE”

Label

Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries.

PC/AT is a registered trademark of International Business Machines Corporation in the United States.

Adobe Acrobat is a trademark of Adobe Systems Incorporated.

Macintosh is a registered trademark of Apple Computer, Inc. in the United States and/or other countries.

All other company or product names are trademarks or registered trademarks of their respective compa- nies.

-2

Page 6
Image 6
Sharp PG-B10S operation manual Product Disposal, When Attaching the Quick Guide Label