TROUBLESHOOTING
If you think the oven is not working properly there are some simple checks you can carry out yourself before calling an engineer. This will help prevent unnecessary service calls if the fault is something simple.
Follow this simple check below:
Place half a cup of water on the turntable and close the door. Programme the oven to cook for 1 minute using 100% microwave power.
1.Does the oven lamp come on when it is cooking?
2.Does the turntable rotate?
3.Does the cooling fan work? (Check by placing your hand above the air vent openings.)
4.After 1 minute does the audible signal sound?
5.Is the water in the cup hot?
Take the cup of water out of the oven and close the door. Programme the oven to cook for 3 minutes using the top and bottom grills.
6.After 3 minutes, do both the grill heating elements become red?
Programme the oven to cook for 3 minutes using the convection on 250°C.
7.After 3 minutes, is the oven cavity hot?
If you answer “NO” to any question first check that the oven is plugged in properly and the fuse has not blown. If there is no fault with either, check against the troubleshooting chart on the following page.
NOTES:
• Safety powerdowns:
WARNING:
Never adjust, repair or modify the oven yourself. It is hazardous for anyone other than a SHARP trained engineer to carry out servicing or repairs.
This is important as it may involve the removal of covers that provide protection against microwave energy.
•The door seal stops microwave leakage during oven operation, but does not form an airtight seal. It is normal to see drops of water, light or feel warm air around the oven door. Food with a high moisture content will release steam and cause condensation inside the door which may drip from the oven.
•Repairs and Modifications: Do not attempt to operate the oven if it is not working properly.
•Outer Cabinet & Lamp Access: Never remove the outer cabinet. This is very dangerous due to high voltage parts inside which must never be touched, as this could be fatal. Your oven is not fitted with a lamp access cover. If the lamp fails, do not attempt to replace the lamp yourself, call a SHARP approved service facility.
IMPORTANT:
If the display is blank and has gone dark, even if the power plug is properly connected, the oven may be in Energy Save Mode. To cancel it, open and then close the oven door, see page 7.
If you cook food for more than the standard time (see chart opposite) using the same cooking mode, the oven’s safety mechanisms automatically activate. The microwave power level will be reduced or the grill heating elements will turn on and off.
•After manual or automatic cooking using the Grill, Combi or Convection modes, the cooling fan will switch on to cool the oven cavity. When the cooling fan works, the display may show “NOW COOLING”. To clear it, press the STOP/CLEAR key and the display will return to “. 0”. During these modes, the cooling fan will carry on working after you have pressed the STOP/CLEAR key. You may feel hot air blowing out of the
SAFETY POWERDOWNS
| Cooking Mode | Standard Time |
Microwave 100% | 20 Minutes | |
cooking |
| |
15 Minutes | ||
15 Minutes | ||
Top Grill 6 Minutes | ||
|
| Btm Grill 6 Minutes |
| ||
|
|
|
| Microwave 100% | Microwave 20 Minutes |
|
| Top Grill 15 Minutes |
| Microwave 10 - 70% | Top Grill 15 Minutes |
|
|
|
| ||
|
|
|
| Microwave 100% | Microwave 20 Minutes |
|
| Btm Grill 15 Minutes |
| Microwave 10 - 70% | Btm Grill 15 Minutes |
36
