Sharp R-890SLM operation manual Troubleshooting, Query, Answer

TROUBLESHOOTING

QUERY			ANSWER
Draught circulates around			When the oven is working, air circulates within the cavity.
the door.			The door does not form an airtight seal so air may escape from the
			door.
Condensation forms in the			The oven cavity will normally be colder than the food being
oven, and may drip from			cooked, and so steam produced when cooking will condense
the door.			on the colder surface.
			The amount of steam produced depends on the water content of
			the food being cooked. Some foods, such as potatoes have a high
			moisture content. Condensation trapped in the door glass should
			clear after a few hours.
Flashing or	arcing	from	Arcing will occur when a metallic object comes into close proximity
within the	cavity	when	to the oven cavity during cooking. This may possibly roughen the
cooking.			surface of the cavity, but would not otherwise damage the oven.
Arcing potatoes.			Ensure all “eyes” are removed from the potatoes and that they have
			been pierced, place directly onto the turntable or in a heat resistant
			flan dish or similar.
The display is lit but the			Check the door is closed properly.
control panel will not work
when pressed.
Oven cooks too slowly.			Ensure correct power level has been selected.
Oven makes a noise.			The microwave energy pulses ON and OFF during cooking/
			defrosting.
Outer cabinet is hot.			The cabinet may become warm to the touch - keep children away.
The display shows message			Your oven may be set in Demo Mode. To cancel Demo Mode, unplug
for “DEMO MODE”, or the			the oven from the socket and replug.
time in the display is counting
down very rapidly.

37