Display Messages

Messages and Signals

Display messages

Note: If you have turned on the Caller ID function, see Caller ID in Chapter 7 for display messages related to Caller ID.

 

The paper size setting is incorrect. Change the paper

CHECK PAPER SIZE

size setting as described in Loading the Paper in

 

Chapter 1.

 

 

 

The print compartment cover (under the operation

 

panel) is open. Open the operation panel (grasp the

COVER OPEN

top and pull toward you), and then press down firmly

 

on both sides of the print compartment cover to close

 

it.

 

 

DOCUMENT JAM

The original document is jammed. See the following

section, Clearing Paper Jams.

 

 

 

 

A fax has been received in memory because the

FAX RX IN MEMORY

imaging film needs replacement, you have run out of

printing paper, or the paper is jammed. The fax will

 

 

print out automatically when the problem is fixed.

 

 

FILM END

The imaging film may need replacement. Check the

film and replace if necessary.

 

 

 

FUNCTION MODE

The FUNCTION key has been pressed.

 

 

 

The HOLD/SEARCH key has been pressed to put

HOLD

the other party on hold during a phone conversation.

Press the HOLD/SEARCH again to take the other

 

 

party off hold.

 

 

 

Transmission or reception was not successful. Press

LINE ERROR

STOP to clear the message, and then try again. If the

error persists, see Line Error in Problems and

 

 

Solutions in this chapter.

 

 

 

An extension phone connected to the fax is being

LINE IS IN USE

used. Do not lift the fax’s handset or attempt

transmission at this time, as this will interrupt the

 

 

conversation on the extension phone.

 

 

11.Trouble-

shooting

 

 

111

Page 113
Image 113
Sharp UX-305 operation manual Messages and Signals, Check Paper Size