Sharp XE-A113 Installing Batteries, Push the printer cover forward and detach it

Part1 QUICK START GUIDE Part2 Part3

2

Installing Batteries

Three new alkaline batteries LR6 (“AA”size) must be installed in the cash register to prevent the data and user-programmed settings from being erased from the memory, when the AC cord is accidentally disconnected or in case of power failure. Once installed, the batteries will last approximately one year before needing replacement. At this time, the “ ” symbol will appear on the display to indicate the batteries are low and must be replaced within two days. If the no battery symbol “ ” appears, you must install the batteries at once.

Do not set the mode switch to the , nor PGM positions while “ ” is being displayed.

Install three new alkaline batteries LR6 (“AA”size) according to the procedure shown below with the AC cord connected and set the mode switch to the REG position:

1.Push the printer cover forward and detach it.

Be careful with the paper cutter, so as not to cut yourself.

2.Open the battery compartment cover next to the paper roll cradle.

3.Install three new alkaline batteries LR6 (“AA”size) as per the diagram. When the batteries are properly installed “ ” on the display will disappear.

4. Close the battery compartment cover.

• Be sure to observe precautions shown on page 1 when handling batteries.

•If you press a key by mistake, an error symbol “ ” may be displayed. Press the lkey to clear

the symbol after installing paper rolls.

“ ” or “ ” can be displayed only when the cash register is being turned on. Please be advised that when the cash register is being turned off for a long time, the data in memory might be cleared without the warning symbols: “ ” or “ ”.

9