Sharp XE-A113 Displays Operator display, Customer display Pop-up type, Machine state symbols

Part1 QUICK START GUIDE Part2 Part3

5

Displays

Operator display

PLU/SUB
DEPT	REPEAT	Clerk code
RCPT		DC SHIFT NUMBER
OFF

Customer display (Pop-up type)

Amount: Appears in the far-right eight (max.) positions. When the amount is negative, the minus symbol “-” appears before the amount.

Number of repeats for repetitive registrations:

The number of repeats is displayed, starting at “2” and incremental with each repeat. When you have registered ten times, the display will show “0.”(2 → 3 ..... 9 → 0 → 1 → 2 ... )

Receipt function status:

The indicator “_” appears in the RCPT OFF position when the receipt function is in the OFF status.

Time: Appears in the second to sixth positions (using 24-hour format) in the OP X/Z, REG or MGR mode. In the REG or MGR mode, press the skey to display the time.

Machine state symbols

: Appears during programming.

: Appears with an error code when an error is detected. For the details of error codes, please refer to “Error code table” on page 31.

: Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount.

: Appears when the Vkey is pressed to calculate a subtotal in foreign currency.

: Appears when a transaction is finalized by pressing the A, X, Y, cor bkey. : Appears when the change due amount is displayed.

: Appears in the far-left three positions at the timing of key entry when the electronic journal (EJ) memory is full. (Depending on programming.)

: Appears when the voltage of the installed batteries is under the required level. You must replace with new ones within two days. Refer to page 76 for details.

: Appears when the batteries are not installed, or the installed batteries are dead. You must replace with new ones immediately. Refer to page 76 for details.

: May appear right below the eighth and ninth places at the timing of finalization of a transaction when the electronic journal (EJ) memory is nearly full.

Also appears right below the tenth place when power save mode is effective.

: Appears when programmed date (and time) for EURO modification operation has come.

: Appears when the print roller arm is not locked.

: Appears when the paper is not set or out.

6

Drawer Lock Key

This key locks and unlocks the drawer. To lock it, turn 90 degrees counterclockwise. To unlock it, turn 90 degrees clockwise.

7