Picture Adjustment (“Picture” Menu) (Continued)
3Switching the Iris Setting
This function controls the quantity of the projected light and the contrast of the image.
IRIS1 (Manual)
Selectable items | Description |
High Brightness | This mode gives priority to brightness |
| over contrast. |
High Contrast | This mode gives priority to contrast |
| over brightness. |
IRIS2 (Auto)
This automatically selects the optimal contrast to match the image.
Selectable items | Description |
On | This mode gives priority to contrast |
| with the use of auto adjustment. |
Off | This mode gives priority to brightness |
| without the use of auto adjustment. |
Menu operation ⇒ Page 35
6Correcting Gradation of Video (Gamma Correction)
When the darker areas of the image become difficult to see because of the image or the projection environment, you can correct the gamma setting to make the image brighter and easier to see.
Selectable items | Description | |
+2 | Provides a brighter gradation. | |
+1 | ||
| ||
0 | Standard setting | |
Provides a darker gradation. | ||
|
7Adjusting the Colors
You can select the color of the projected image to correct and then adjust it to the desired color by setting “Hue”, “Saturation”, “Value”, and “Effect”.
Note
•You can also use IRIS 1, 2 on the remote con- trol to change the Iris. (See page 29.)
4Eco+Quiet
Selectable items | Brightness and Power consumption |
On | Approx. 75% |
Off | 100% |
Note
•When “Eco+Quiet” is set to “On”, the power consumption will decrease and the lamp life will extend. (Projection brightness decreases approximately 25%.)
5Using the Advanced
“Advanced” allows you to make even finer adjustments to the image so that it appears just the way you want it to.
To display the Advanced menu, select “Advanced” and press ENTER.
Note
•When the “Advanced” settings are displayed, select “Advanced” again and press ENTER to return to the “Picture” menu.
Note
•Before performing this adjustment, prepare the image to be adjusted.
•You can perform this adjustment easier in the still image than in the moving image.
1
Select “C.M.S.1” or “C.M.S.2” (C.M.S.: Color Management Sys- tem) in the “Advanced” menu, and press ENTER.
•If there is no data for the stored corrected color, the color selection screen and the picker is displayed. (Go to step 2.)
Picker
-38
