Sherwood R-871 Operating a punch-throughfunction, Erasing the programmed puch-throughfunction

ENGLISH

Operating a punch-through function

• While this remote control is set to control a	• Then the punch-through device is displayed on
master device, aim the remote control at the	the LCD screen.
REMOTE SENSOR of the punch-through
device and press the desired button of the
programmed punch-through controls.
Example: When pressing “PLAY (▶)” button.

Erasing the programmed puch-through function

Perform the steps ③ and ④ in

1“Entering a setup code” procedure on page 20 to select a master device and the punch-through mode (“PUNCH”).

•Then “VOL” is displayed on the LCD screen for several seconds.

While the device is displayed, press

3the CURSOR UP(▲)/DOWN(▼) buttons to select the one punch- through deleting mode(“DELETE”), then press the ENTER button.

•Each time theCURSOR UP(▲)/DOWN(▼) buttons are pressed, depending on the selected punch-through mode, the punch- through devices and the deleting mode (“DELETE”) are selected.

•Then “OK” is displayed and the current punch- through mode is displayed .

While “VOL” is displayed, press the

2CURSOR UP(▲)/DOWN(▼) buttons to select the punch-through mode to be erased, then press the ENTER button.

•Each time theCURSOR UP(▲)/DOWN(▼) buttons are pressed, the mode changes as follows:

→ VOL DELETE PLAY CH ←

• Then the device is displayed .

While the punch-through mode is

4displayed, repeat the above steps ② and ③ to erase other punch-through function under the same master device mode.

To erase punch-through functions

5under other master device mode, repeat the above steps ① to ④.

26