Erasing the programmed command | While “BTTN” is displayed, press the | |
CURSOR UP(▲)/DOWN(▼) buttons to | ||
from one button | ||
2 select the one command deleting mode | ||
| ||
| ||
Perform the steps ③ and ④ in | (BTTN), then press the ENTER button. | |
|
1“Entering a setup code” procedure on page 20 to select the delecting mode
(“DELETE”).
• Then “BTTN” is displayed on the LCD screen for several seconds.
While “SEL” is flickering, press the |
|
| |
3 erase.button for the command you want to | •Each time the CURSOR UP(▲)/DOWN(▼) | ||
Example: When the button for the command to be | buttons are pressed, “BTTN” or “LEARN”(all | ||
command deleting mode) is selected. | |||
erased is PLAY button. | |||
•Then “SEL” is flickering. | |||
| |||
| •If “SEL” goes off, start again from the above | ||
| step ①. |
| |
| 4 | While “SEL” is flickering, repeat the | |
| above step ③ to erase other | ||
| commands. |
• “OK” is displayed and then “SEL” is flickering.
Erasing all the commands | 2 | While “BTTN” is displayed, press the | |
programmed under a device mode | CURSOR UP(▲)/DOWN(▼) buttons to | ||
|
| select the all command deleting mode | |
1 | Perform the steps ③ and ④ in |
| (“LEARN”), then press the ENTER |
| button. | ||
“Entering a setup code” procedure on |
| ||
|
| ||
page 20 to select the deleting mode |
|
| |
| (“DELETE”). |
|
|
• Then “BTTN” is displayed on the LCD screen |
|
| |
for several seconds. |
|
| |
3 | While “SURE?” is displayed, press the |
|
|
ENTER button |
|
| |
|
| •Then “SURE?” is displayed . | |
|
| •If “SURE?” goes off, start again from the | |
|
| above step ①. | |
|
| 4 | To erase all the commands |
|
| programmed under other device mode, | |
|
| repeat the above steps ① to ③ . |
•Then all the commands programmed are erased.
ENGLISH
23