ENGLISH
When selecting the SPEAKER CROSSOVER
•When speakers are set to "SMALL", be sure to set their crossover frequency correctly according to their frequency characteristics.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the SPEAKER CROSSOVER, then
1 press the ENTER button.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired speaker.
2
■Note :
• You cannot select the subwoofer and the speakers set to "NONE".
Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the crossover frequency as desired.
3
• You can adjust the crossover frequency within the range of 40 ~ 200 Hz in 10 Hz intervals.
4 | Repeat the above steps ② and ③ until the crossover frequencies are all set as desired. |
■About the crossover frequency
•When speakers are set to "SMALL", low frequencies in those channels that are below the crossover frequency are to output from subwoofer or front speakers which are set to LARGE(when not using a subwoofer).
•Refer to the operating instructions of the speakers to be connected. If the frequency range of your speaker is 100 Hz~20 kHz, the crossover frequency should be set to 100 Hz(or slightly higher).
60
