Sherwood R-871 manual Using Functions of Remote Control, Entering a setup code

ENGLISH

USING FUNCTIONS OF REMOTE CONTROL

•This remote control can control up to 8 different components.

•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.

•For system remote control operation, “000” was stored previously in the memory of the device button “CD” for Sherwood CD player, “DVD” for Sherwood DVD player, “AUX” for Sherwood tape deck and “TV” for Sherwood TV respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.

	Entering a setup code		Find the setup codes according to the
• Setup code entry is the easiest way to program		2
			type and the brand name of your
	this remote control for operating audio and
			component, referring to “Setup Code
	video components.
			Table” on page 71.

Turn on the component you want to

1operate

3	Press and hold down both the ENTER	4	While “LEARN” is displayed, press the
	button and the desired one of the		CURSOR UP(▲)/DOWN(▼) buttons to
	DEVICE buttons for more than 2		select the setup code mode (“CODE”),
	seconds.		then press the ENTER.

• Then “LEARN” is displayed on the LCD screen	•Each time the CURSOR UP(▲)/DOWN(▼) buttons
for several seconds.
	are pressed, the mode changes as follows :
■Notes:		LEARN	DELETE MACRO
		CODE	PUNCH
• The AUDIO button is unavailable for the audio
components other than this receiver.	•Then “PRESET” and 3 digit number are displayed.
• During setting operation, to exit from the setting
	•If “PRESET”, etc. go off, start again from the above
mode, press any of the DEVICE buttons.
	step ③.

While “PRESET”, etc. are displayed, enter a 3 digit code and press the ENTER button,

5aiming the remote sensor on the component.

Example: When entering "001".	• Then “OK” is displayed on the LCD screen.
	• To be sure that the setup code is correct, press the
	POWER ON (or STANDBY) button.
	• If the setup code is correct, your component will be
	turned off.
	• When your component is not turned off, repeat the
	above steps ② to ⑤, trying entering each code for
	your component until you find one that works.
	• If “NG” is displayed, retry entering the correct
	setup code while “PRESET” and 3 digit number
	are displayed.

20