Sherwood R-871 manual Connecting Audio Components, Continued, English

Continued

•There are three types of video jacks (COMPONENT, S-VIDEO, (composite) VIDEO) for connecting video components.

Connect them to the corresponding video jacks according to their capability.

•For your reference, the excellence in picture quality is as follows : “COMPONENT” >“S-VIDEO”> “(composite) VIDEO” .

•When making COMPONENT VIDEO connections, connect “Y” to “Y”, B/“PCB” to “CB”(or “B-Y”, “PB”) and “PR/CR” to “CR”(or “R-Y”, “PR” ).

•When recording video program sources through VIDEO 1 OUT jacks or viewing ROOM 2 source through ROOM 2 OUT jack, you must use the same type of video jacks that you did connect to video playback components such as DVD player, LD player, etc.

•This unit is equipped with a function that up-converts composite video or S-Video signals to component video signals or down-converts S-Video signals to composite video signals and outputs them from the MONITOR OUTs. Because of this, you need not connect all the types of MONITOR OUT jacks to the MONITOR TV.

•After connecting the video components, you should set the video mode correctly, reffering to the following table. (For details, refer to "When selecting the VIDEO MODE" on page 53.)

■Relationship between the video input signal and the video output signal

	Video input signals			Video Mode		MONITOR OUTs
				Setting
COMPONENT		S-VIDEO	(COMPOSITE) VIDEO		COMPONENT	S-VIDEO	(COMPOSITE) VIDEO
				Auto	Component	S-Video	Composite video*3
×		×	◯
×		×	◯	Component *1	Component	×	×
◯		◯	◯
				S-Video*2	S-Video	S-Video	S-Video
×◯◯		×	◯
×		×	◯	Composite*2	Composite video	Composite video	Composite video
◯		◯	×	Auto	Component	S-Video	S-Video
◯		×	◯	Auto	Component	Composite video	Composite video
◯		×	×	Auto	Component*4	×	×
×		◯	◯	Auto	S-Video	S-Video	Composite video*3
×		◯	×	Auto	S-Video	S-Video	S-Video
×		×	◯	Auto	Composite video	Composite video	Composite video

*1 : Component video signal can be output from the MONITOR COMPONENT OUT jacks only.

*2 : The video signal set in the VIDEO MODE menu can be output from all the types of MONITOR OUT jacks.

*3 : The OSD menu and the momentary OSD cannot be displayed via MONITOR COMPOSITE jack.

*4 : If the OSD menu operation is performed, the picture is automatically turned off and only the OSD menu is displayed via MONITOR COMPONENT OUT jacks.

■Note :

•When outputting the component video signal from the MONITOR COMPONENT OUT jacks as it was input, the momentary OSD cannot be displayed.

3.CONNECTING AUDIO COMPONENTS

•The TAPE IN/OUT jacks can be connected to audio recording equipment such as a tape deck, an MD recorder, etc.

ENGLISH

7