SETTING THE SPEAKER SETUP AUTOMATICALLY (AUTO SPEAKER SETUP) 
•Auto Speaker Setup lets you avoid troublesome
You should connect the microphone to the SETUP MIC jack so that this receiver can analyze the information from a series of test tones emitted from speakers and can adjust the size, distance and sound level of each speaker automatically.
•If you want to personalize your speaker setup and channel level setup by making the settings manually, perform the
“SETTING THE SPEAKER SETUP MANUALLY” procedure on page 20, “Adjusting each channel level with test tone” procedure on page 32 and “Adjusting the current channel level” procedure on page 33.
Note:
•Because the microphone for Auto Speaker Setup is designed for use with this receiver, to use the auto speaker setup function, do not use a microphone other than the one supplied with this receiver.
Before setting the speaker setup
• Press the POWER switch to enter the standby mode and then turn the power on.
POWER | POWER ON |
| STANDBY |
ON/ OFF | ON/STANDBY |
or
ENGLISH
Connect the optional microphone to the
1 SETUP MIC jack on the rear panel.(For details, refer to “CONNECTING MICROPHONE” on page 10.)
2 | Place the microphone on a flat level |
surface at your normal listening position. |
•If possible, use a tripod, etc. to attach the microphone at the same height as your ears would be when you are seated in your listening position.
•Ensure there are no obstacles between the speakers and the microphone.
Press and hold down the SPEAKER SETUP
3 button on the front panel for more than 2 seconds to enter the auto speaker setup mode.
• Then “SET ALL S” is displayed.
• For your reference, the default settings for auto speaker setup are as follows:
SPEAKER
SETUPSpeaker layout: ALL channels, Subwoofer: Yes,
CUToff frequency: 80 Hz
• When performing auto speaker setup according to the default settings, skip the step and perform the step .
• However, you can specify these settings according to the number of speakers installed and speakers’ frequency characteristics with performing the step .
• To cancel the auto speaker setup mode, press and hold down the SPEAKER SETUP button on the front panel for more than 2 seconds again.
22
