USING FUNCTIONS OF REMOTE CONTROL
•This remote control can control up to 8 different components.
•Before operating audio and video components other than this receiver with using this remote control, the setup code for each component should be entered.
•For system remote control operation, “000” was stored previously in the memory of the device button “CD” for Sherwood CD player, “DVD” for Sherwood DVD player and “AUX” for Sherwood tape deck respectively as its factory setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not work.
| Entering a setup code |
|
|
| |
| 1 | Turn on the component you want to control. | 2 | Find the setup codes according to the type | |
|
|
| and the brand name of your component, | ||
|
|
| referring to “Setup Code Table” on page 52. | ||
|
|
|
|
| |
| 3 | Press and hold down both the “ENTER” | 4 | Enter a 3 digit code, aiming the remote control | |
| button and the desired one of the DEVICE | at the remote sensor on the component. | |||
| buttons for more than 1 second. | Example) When entering “001”. | |||
AUD | CD | AUX | TV |
VCR | DVD | SAT | CBL |
|
| TUNER |
0 | 0 | 1 |
ENTER |
|
|
|
|
|
| • If entering is performed successfully, the LED will | |
|
|
|
| flicker twice. |
|
|
|
|
| • To be sure that the setup code is correct, press the | |
• The LED will flicker once. | POWER(or STANDBY) button. | ||||
|
|
|
| If your component is tuned off, the setup code is correct. | |
Note: |
|
|
| • When your component is not turned off, repeat the | |
• The “AUD” button is unavailable for the audio | above steps | to , trying each code for your | |||
components other than this receiver. | component until you find one that works. | ||||
|
|
|
| Notes: |
|
|
|
|
| • If the LED did not flicker twice, then repeat the above | |
|
|
|
| steps to | and try entering the same code again. |
|
|
|
| • Manufacturers may use different setup codes for the | |
|
|
|
| ||
| Repeat the above steps to for each of | same product category. For that reason, it is important | |||
5 | that you check to see if the code you have entered | ||||
your components. | operates as many controls as possible. If only a few | ||||
|
|
| functions operate, check to see if another code will | ||
|
|
|
| work with more buttons. | |
|
|
|
| • When operating a Sherwood CD player or tape deck | |
|
|
|
| using the system remote control, aim the remote | |
|
|
|
| control at the REMOTE SENSOR on this receiver. | |
|
|
|
| However, in case of Sherwood DVD player and MD | |
|
|
|
| recorder, aim it at the REMOTE SENSOR on the | |
|
|
|
| corresponding component. | |
16
ENGLISH
