Sherwood RD-8601 operating instructions Adjusting the current channel level, English

ENGLISH

At each channel, adjust the level as

2 desired until the sound level of each speaker is heard to be equally loud.

CH/LEVEL

ADJUST

or

• You can select the desired channel and adjust its level with repeating the steps and in “Adjusting the current channel level” procedure.

Cancel the test tone function.

3

T.TONE

MENU

Adjusting the current channel level

•After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or to suit your tastes.

•You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory(“USER”), not into preset memory(“REF. 1”, “REF. 2”).

Press the CHANNEL SELECTOR button.

1

CHANNEL	CH.SEL
SELECTOR	T/V

or

•Each time this button is pressed, “REF. 1” (or “USER”) is displayed and the corresponding channel is selected as follows:

REF. 1(or USER) FL		C FR	SR SB
	<DTS L or DD L>	SW	SL
	DTS LFE Dolby Digital LFE

<>: Possible only when the digital signals from Dolby Digital or DTS program sources that include LFE signal are input.

•Depending on the speaker setting and surround mode, etc., some channels cannot be selected.

•When the SPEAKER button is set to off, only the front L/R channel can be selected.

Adjust the level of the selected channel as desired.

2	• The LFE level can be adjusted within the range of
	-10~0 dB and other channel levels within the range
	of -15~+15 dB.
CH/LEVEL	• In general, we recommend the LFE level to be
ADJUST	adjusted to 0 dB.(However, the recommended LFE
	level for some early DTS software is -10 dB.) If the
or	recommended levels seem too high, lower the setting
	as necessary.
	• If the channel display disappears, start from the step
	again.
Repeat the above steps	and to adjust each channel level.

3

33