Sherwood RD-8601 Tuning to preset stations, Listening to FM stereo broadcasts, English

Select the desired preset number (1~30) and		Repeat the above steps to to
3 press the MEMORY/ENTER button.		4 memorize other stations.
TUNING/PRESET	MEMO/ENTER

• The station has now been stored in the memory.		MEMORY BACKUP FUNCTION
• A stored frequency is erased from the memory by		The following items, set before the receiver is turned
storing another frequency in its place.		off, are memorized.
• If “MEM” goes off, start again from the above		• INPUT SELECTOR settings
step .		• Surround mode settings
		• Preset stations,etc.
Tuning to preset stations		Select the desired preset number.
1	After selecting the tuner as an input	2
	source, select the preset tuning mode.
	T/P MODE	TUNING/PRESET
		or
		PRESET PRESET
• Then “PRESET” lights up.		• When pressing the PRESET +/- buttons on the remote
		control, you need not select the preset tuning mode on
		step .
Listening to FM stereo broadcasts		Scanning preset stations in sequence
• While listening to FM broadcasts.
	FM MODE
		P.SCAN
• Each time this button is pressed, the FM mode changes
as follows;
Stereo mode : “ST” lights up.
Mono mode : “ST” goes off.		• The receiver will start scanning the stations in the preset
• When FM stereo broadcasts are poor because of weak		sequence and each station is received for 5 seconds.
		• At the desired station, press this button again to stop
broadcast signals, select the FM mono mode to reduce
		scanning.
the noise, then FM broadcasts are reproduced in
monaural sound.

ENGLISH

36