Installing the Telephone | Setting Up the Telephone |
Starting up the optiPoint 410/420
7Only use switches in the LAN, to which the optiPoint 410/420 is connected. An operation at hubs can cause serious malfunctions in the hub and in the whole network.
The Western plugs of all cable connections must audibly snap into place.
•Plug the short end of the handset cable into the handset and the other end into the connector 7 at the bottom of the telephone and feed the cable through the guide channel in the base unit.
•Using the headset connector:
Plug the jack of the headset cable into connector 6 at the bottom of the telephone and feed the cable through the guide channel in the base unit.
•Using optiPoint modules (4):
Mount this device following the instructions in the installation guide
•Using adapter (7, 8):
Mount this device following the instructions in the installation guide
•Using the external keyboard:
Plug the keyboard cable into the USB connector 9 at the bottom of the telephone.
•Using a LAN connection to PC:
Plug the jack of the connection cable into the connector 5 at the bottom of the telephone.
Only if power not supported by LAN:
7Use only the
– GER/IM: AUL:06D1284
– GBR: AUL:06D1287
– USA: AUL:51A4827
– Plug the
– Plug the connector 3 at the bottom of the telephone into the
• Plug the jack of the LAN cable into the connector 4 at the bottom of the telephone and connect the cable with LAN.
• Feed the cables through the relief on the back of the housing and fix them by means of the cable clip.
13