Siemens MC35 manual Atssta Remote-SAT Activation, Atssta=?, Atssta?

Remote-SAT User's Guide

1.2 AT^SSTA Remote-SAT Activation

Test command

AT^SSTA=?

Read command

AT^SSTA?

Write command

AT^SSTA=

<mode>

[,<Alphabet>]

Response

^SSTA:(list of supported <state>s), (list of supported <alphabet>s) Parameter description see below.

The read command can be used to request the current operating status and the used alphabet of the Remote-SAT interface.

State handling is described in chapter “States of Remote-SAT”,pg. 10.

Response

^SSTA:<state>,<alphabet>,<allowedInstance>,<SatProfile>

<state>	device is in one of the following state:
	0	RESET
	1	OFF
	2	IDLE *)
	3	PAC
	4	WAIT

*) Note:

Only this state can be selected directly by the TA, see write command.

<allowedInstance>

0SAT is already used on an other instance (logical channel in case of the multiplex protocol). Only test and read commands can be used.

1SAT may be started on this instance via the write version of this command (see below).

<SatProfile>

SAT profile according to GSM 11.14, see appendix.

The profile tells the SIM application which features are supported by the SIM Application Toolkit implemented by the ME. The profile cannot be changed by the TA.

The write command activates the AT command interface to the SIM Application Toolkit in the ME. It must be issued each time the ME is switched on again. However, removing and inserting the SIM does not affect the activation status.

SAT commands which are not using the AT interface (non MMI related SAT commands , e.g. PROVIDE LOCAL INFORMATION) may be executed without activating Remote-SAT.

Response

OK

MC35_SAT_01_v02.00 Page 20 of 65 11.01.2002