1.4.2 AT^SSTGI Remote-SAT Get Information – Refresh (1)
Write command
AT^SSTGI=1
This command is to be used upon receiving an unsolicited result code ^SSTN:1.
The response from the module indicates the type of REFRESH that is going to be undertaken.
Response
^SSTGI: <cmdType>, <commandDetails> <CR> <LF>
Parameters |
|
|
<cmdType> | 1 – Proactive command ID, see Table 1 | |
<commandDetails> | Unsigned Integer, range 0 – 255, used as an | |
| enumeration. | |
| 0 | SIM Initialization and Full File Change |
|
| Notification; |
| 1 | File Change Notification; |
| 2 | SIM Initialization and File Change Notification; |
| 3 | SIM Initialization; |
| 4 | SIM Reset; ME is performing a SIM reset. |
|
| Therefore a Terminal Response should not be |
|
| issued. |
5 to 255 = reserved values.
For every return value of <commandDetails> except 4 (SIM reset) the external application shall react as follows:
1.Issue the related Terminal Response AT^SSTR=1,<status>.
2.If <status> is 0 (Command performed successfully) the TA is requested to show a “Please wait” alert window on its screen until it will receive the RSAT notification ^SSTN:101 (Terminate proactive command REFRESH).
ReferenceNote
Siemens
MC35_SAT_01_v02.00 | Page 24 of 65 | 11.01.2002 |
