1.5.2Proactive Commands
1.5.2.1AT^SSTR Remote-SAT Response – Refresh (1)
Write command
AT^SSTR=1,
<status>
If <cmdDetail> reported by AT^SSTGI was 4, ME is performing a SIM reset. Therefore a Terminal Response should not be issued.
Response
OK
Parameters
<cmdType> 1 – Proactive command ID, see Table 1
<status> Unsigned Integer, range
0 | Command performed successfully |
32 | TA currently unable to process command |
132TA currently unable to process command because screen is busy.
ReferenceNote
Siemens
1.5.2.2 AT^SSTR Remote-SAT Response – Set Up Event List (5)
Write command
AT^SSTR=5,
<status>
Reference
Siemens
The TA is acknowledging that the Event list has been set up correctly.
Response
OK
Parameters
<cmdType> 5 – Proactive command ID, see Table 1
<status> Unsigned Integer, range
0 | Command performed successfully |
32 | TA currently unable to process command |
132TA currently unable to process command because screen is busy.
Note
MC35_SAT_01_v02.00 | Page 43 of 65 | 11.01.2002 |