Siemens MC35 manual Atsstgi Remote-SAT Get Information, Atsstgi=?, Atsstgi?

Remote-SAT User's Guide

1.4AT^SSTGI Remote-SAT Get Information

1.4.1AT^SSTGI Remote-SAT Get Information – Generic Format

Test command

AT^SSTGI=?

Read command

AT^SSTGI?

Write command

AT^SSTGI=

<cmdType>

Response

^SSTGI:(list of supported <state>s), (list of supported <cmdType>s)

OK

Response

^SSTGI: <state>, <cmdType>

OK

Parameters
<state>	Remote-SAT interface states (refer to AT^SSTA)

<cmdType> Ongoing Proactive Command (values see chapter 1.1.4 “Command Type Values”). However, this information is valid during states PAC and WAIT only.

There are two situations for use of the Write command:

1.Regularly the Write command is used upon receipt of an unsolicited result code ^SSTN:<cmdType>.

In this case the TA is expected to acknowledge the ^SSTGI response with AT^SSTR to confirm that the proactive command has been executed. AT^SSTR will also provide any user information e.g. selected menu item.

2.There may be the situation to request the information via AT^SSTGI without previously receiving an URC ^SSTN:<cmdType>.

This will always be the case if the TA has started or restarted its application (e.g. a MMI) after power on the ME.

To request the information despite the probably missed URCs it is possible to issue AT^SSTGI during states IDLE, PAC and WAIT at any time for the

following Proactive Commands: PAC type 5: Set Up Event List, PAC type 37: Setup Menu,

PAC type 40: Setup Idle Mode Test.

Note:

In case of using the Write command without receipt of an unsolicited result code ^SSTN:<cmdType> it is neither necessary nor possible to acknowledge the ^SSTGI response with AT^SSTR.

Such a ^SSTGI response will not cause any state changes.

The command type value is returned to the ME to identify which ^SSTN is being responded to.

ReferenceNote

Siemens

MC35_SAT_01_v02.00 Page 23 of 65 11.01.2002