Siemens MC35 manual Atsstgi Remote-SAT Get Information Get Input, ATSSTGI=35

Remote-SAT User's Guide

1.4.12 AT^SSTGI Remote-SAT Get Information – Get Input (35)

Write command

AT^SSTGI=35

This command is to be used upon receiving an unsolicited result code ^SSTN:35.

The TA is asked to prompt the user for an input, of a specified length and type, e.g. digits only. Help can be requested by the user, if available.

Text and an Icon Identifier can be passed to the TA to display to the user.

Response

^SSTGI: <cmdType>, <commandDetails>, <text>, <responseMin>, <responseMax>, [<defaultText>], <iconQualifier>, <iconId> <CR> <LF>

Parameters
<cmdType>	35 – Proactive command ID, see Table 1
<commandDetails>	Unsigned Integer, range 0 – 255, used as a bitfield.
	bit 1:	0	= digits (0-9, *, #, and +) only
		1	= alphabet set
	bit 2:	0	= SMS default alphabet (GSM character set)
		1	= UCS2 alphabet
	bit 3:	0	= ME may echo user input on the display
		1	= user input shall not be revealed in any way
		(see note)
	bit 4:	0	= user input to be in unpacked format
		1	= user input to be in SMS packed format
	bits 5 to 7: RFU
	bit 8:	0	= no help information available
		1	= help information available
<text>	String as prompt for text
<responseMin>	minimum length of user input (0 – 255)
<responseMax>	maximum length of user input (0 – 255)
<defaultText>	String supplied as default response text
<iconQualifier>	Unsigned Integer, range 0 – 255, used as a bitfield.
	bit 1:	0	= icon is self explanatory and replaces text
		1	= icon is not self-explanatory and shall be
		displayed with the text
		Determined value only if associated icon id is
		not 0 (an icon exists).
	bits 2-8: = RFU
<iconId>	0-255, 0: no icon

Reference	Note
Siemens	Hidden entry mode (GSM 11.14) is only available when using digit input. In
	hidden entry mode only characters ‘0’-‘9’, ‘*’ and ‘#‘ are allowed.

MC35_SAT_01_v02.00 Page 35 of 65 11.01.2002