Siemens MC35 manual Atsstr Remote-SAT Event Response Idle Screen Available, ATSSTR=233, ATSSTR=254

Remote-SAT User's Guide

1.5.3.3 AT^SSTR Remote-SAT Event Response – Idle Screen Available (233)

Write command	Sent by the customer application to indicate that the screen has become idle.
AT^SSTR=233	Response
	OK
	Parameters
	<cmdType>	233 – Event command ID, see Table 1.
Reference	Note
Siemens

1.5.3.4 AT^SSTR Remote-SAT Event Response – Language Selection (235)

Write command

AT^SSTR=235, , , <inputString>

Reference

Siemens

Sent by the customer application to indicate that the customer application has changed language.

Response

OK

Parameters
<cmdType>	235 – Event command ID, see Table 1
<inputString>	Two character language tag, e.g. “en” for English or
	“de” for German, refer to appendix.
Note

1.5.3.5 AT^SSTR Remote-SAT Event Response – Terminate Command (254)

Write command

AT^SSTR=254

Reference

Siemens

This command allows the TA to finish an ongoing proactive command, if any. This is done by sending a Terminal Response “ME currently unable to process command - screen is busy” to the SIM (see table “Remote-SAT Command Status”, pg. 42), if issued in states PAC or WAIT. No action is performed if the interface is already in IDLE state. However, command returns “OK”.

The actual reaction regarding the Terminal Response depends on the SIM application.

The command can be used to return to IDLE state regardless whether a Proactive command is ongoing or not.

Response

OK

Parameters
<cmdType>	254 – Event command ID, see Table 1
Note

This command is allowed in states IDLE, PAC and WAIT and forces a return to IDLE state once it has been issued successfully, i.e. OK response.

MC35_SAT_01_v02.00 Page 57 of 65 11.01.2002