AMX NI-3000 Sendcommand DEV, GET Mode, Sendcommand IR1,GET Mode, Port 4 IR,CARRIER,IO Link

Programming

IR/Serial Send_Commands (Cont.)

GET MODE Syntax:

Polls the IR/Serial ports and	SEND_COMMAND <DEV>, 'GET MODE'
reports the active mode	Example:
settings to the device
	SEND_COMMAND IR_1,'GET MODE'
requesting the information.
	System response example:
	PORT 4 IR,CARRIER,IO LINK 0
IROFF	Syntax:
Halts and clears all IR output	SEND_COMMAND <DEV>,'IROFF'
on the designated port.	Example:
	SEND_COMMAND IR_1,'IROFF'
	Immediately halts and clears all IR output signals on the IR_1 port.
POD	Channel 255 changes are enabled. This command is used in conjunction with
Disables active PON (power	the I/O Link command.
on) or POF (power off)	Syntax:
command settings.	SEND_COMMAND <DEV>,'POD'
	Example:
	SEND_COMMAND IR_1,'POD'
	Disables PON and POF command settings on the IR_1 device.
POF	If at any time the IR sensor reads that the device is on (such as if one turned it
Turns off a device, based on	on manually at the front panel), the card automatically attempts to turn the
	device back off. If three attempts fail, the card will continue executing
input Link.
	commands in the buffer. If there are no commands in the buffer, the card will
	continue to try until a 'PON' or 'POD' command is received. If it fails to turn the
	device off, a PUSH and RELEASE is made on channel 254 to indicate a power
	failure error.
	Channel 255 changes are disabled after receipt of this command.
	You can only use the PON and POF commands when an IR device has a
	linked I/O channel.
	Syntax:
	SEND_COMMAND <DEV>,'POF'
	Example:
	SEND_COMMAND IR_1,'POF'
	Sends power down IR commands 28 (if present) or 9 to the IR_1 device.
PON	If at any time the IR sensor reads that the device is off (such as if one turned it
Turns on a device, based on	off manually at the front panel), the card automatically attempts to turn the
	device back on. If three attempts fail, card will continue executing commands in
input Link.
	the buffer. If there are no commands in the buffer, the card will continue to try
	until a 'POF' or 'POD' command is received. If it fails to turn the device on, a
	PUSH and RELEASE is made on channel 254 to indicate a power failure error.
	Channel 255 changes are disabled after receipt of this command.
	You can only use the PON and POF commands when an IR device has a
	linked I/O channel.
	Syntax:
	SEND_COMMAND <DEV>,'PON'
	Example:
	SEND_COMMAND IR_1,'PON'
	Sends power up IR commands 27 or 9 to the IR_1 port.

120 NetLinx Integrated Controllers