AMX NI-3000, NI-4000, NI-2000 instruction manual Rear Panel Components

Introduction

NI-4000 Specifications (Cont.)

Relay LEDs	• Eight red LEDs light to indicate the rear relay channels 1-8 are active
	(closed)
	• These LEDs reflect the state of the relay on Port 8
	• If the relay is engaged = LED On and if the relay is Off = LED Off
IR/Serial LEDs	• Eight red LEDs light to indicate the rear IR/Serial channels 1-8 are
	transmitting control data on Ports 9-16
	• LED indictor for each IR port remains lit for the length of time that IR/Serial
	data is being generated
I/O LEDs	• Eight yellow LEDs light when the rear I/O channels 1-8 are active
	• LED indicator for each I/O port reflects the state of that particular port
NetLinx Control	Accepts up to 4 compatible NetLinx Control Cards:
Card slots 1- 4	• NXC-COM2 Dual COM Port Control Card (FG2022)
	• NXC-I/O10 Input/Output Control Card (FG2021)
	• NXC-IRS4 4-Port IR/S Control Card (FG2023)
	• NXC-REL10 Relay Control Card (FG2020)
	• NXC-VAI4 Analog Voltage Control Card (FG 2025)
	• NXC-VOL4 Volume Control Card (FG2024)
Rack-mount brackets	• Provide an installation option for the Integrated Controller to be mounted
	into an equipment rack.
Rear Panel Components:
RS-232/422/485 (Ports 1 -7)	• Seven RS-232/422/485 control ports using DB9 (male) connectors with
	XON/XOFF (transmit on/transmit off), CTS/RTS (clear to send/ready to
	send), and 300-115,200 baud.
	• Channel range = 1-255
	• Channels 1-254 provide feedback
	• Channel 255 (CTS Push channel): Reflects the state of the CTS Input if a
	'CTSPSH' command was sent to the port
	• Output data format for each port is selected via software
	• Seven DB9 connectors provide RS-232/422/485 termination
ICSNet	• Two RJ-45 connectors for ICSNet interface
ICSHub Out	• Single RJ-45 connector provides data to another Hub connected to the
	Controller
Relay (Port 8)	• Eight-channel single-pole single throw relay ports
	• Each relay is independently controlled.
	• Supports up to 8 independent external relay devices
	• Channel range = 1-8
	• Each relay can switch up to 24 VDC or 28 VAC @ 1 A
	• Two 8-pin 3.5 mm mini-Phoenix (female) connectors provide relay
	termination

12 NetLinx Integrated Controllers