AMX NI-3000, NI-4000, NI-2000 instruction manual Front Panel Components, Rear Panel Components

	Introduction
NI-2000 Specifications (Cont.)
Front Panel Components:
LINK/ACT	• Green LED lights when the Ethernet cable is connected and an active link
	is established. This LED also blinks when receiving Ethernet data packets.
Status	• Green LED lights to indicate that the system is programmed and
	communicating properly.
Output	• Red LED lights when the Controller transmits data, sets channels On/Off,
	sends data strings, etc.
Input	• Yellow LED blinks when the Controller receives data from button pushes,
	strings, commands, channel levels, etc.
RS-232/422/485 LEDs	• Three sets of red and yellow LEDs light to indicate the rear DB9 Ports 1-3
	are transmitting or receiving RS-232, 422, or 485 data:
	- TX LEDs (red) light when transmitting data
	- RX LEDs (yellow) light when receiving data
	- LED activity reflects transmission and reception activity
Relay LEDs	• Four red LEDs light to indicate the rear relay channels 1-4 are active
	(closed).
	• These LEDs reflect the state of the relay on Port 4
	• If the relay is engaged = LED On and if the relay is Off = LED Off
IR/Serial LEDs	• Four red LEDs light to indicate the rear IR/Serial channels 1-4 are
	transmitting control data on Ports 5-8
	• LED indictor for each IR port remains lit for the length of time that IR/Serial
	data is being generated
I/O LEDs	• Four yellow LEDs light when the rear I/O channels 1-4 are active
	• LED indicator for each I/O port reflects the state of that particular port
Rack-mount brackets	• Provide an installation option for the Integrated Controller to be mounted
	into an equipment rack.
Rear Panel Components:
RS-232/422/485 (Ports 1 -3)	• Three RS-232/422/485 control ports using DB9 (male) connectors with
	XON/XOFF (transmit On/transmit Off), CTS/RTS (clear to send/ready to
	send), and 300-115,200 baud.
	• Channel range = 1-255
	• Channels 1-254 provide feedback
	• Channel 255 (CTS Push channel): Reflects the state of the CTS Input if a
	'CTSPSH' command was sent to the port
	• Output data format for each port is selected via software
	• Three DB9 connectors provide RS-232/422/485 termination
ICSNet	• Two RJ-45 connectors for ICSNet interface
ICSHub Out	• Single RJ-45 connector provides data to another Hub connected to the
	Controller
Relay (Port 4)	• Four-channel single-pole single-throw relay ports
	• Each relay is independently controlled.
	• Supports up to 4 independent external relay devices
	• Channel range = 1-4
	• Each relay can switch up to 24 VDC or 28 VAC @ 1 A
	• One 8-pin 3.5 mm mini-Phoenix (female) connector provides relay
	termination

NetLinx Integrated Controllers 3