Siemens MC35 manual Atsstgi Remote-SAT Get Information Get Inkey, ATSSTGI=34

Remote-SAT User's Guide

1.4.11 AT^SSTGI Remote-SAT Get Information – Get Inkey (34)

Write command

AT^SSTGI=34

This command is to be used upon receiving an unsolicited result code ^SSTN:34.

The TA is asked to prompt the user for an input, which is a single character. Help can be requested by the user, if available.

Text and an Icon Identifier can be passed to the TA to display to the user.

Response

^SSTGI: <cmdType>, <commandDetails>, <text>, <iconQualifier>, <iconId> <CR> <LF>

Parameters
<cmdType>	34 – Proactive command ID, see Table 1
<commandDetails>	Unsigned Integer, range 0 – 255, used as a bitfield.
	bit 1:	0 = digits (0-9, *, # and +) only
		1 = alphabet set;
	bit 2:	0 = SMS default alphabet (GSM character set)
		1 = UCS2 alphabet
	bit 3:	0 = character sets defined by bit 1 and bit 2 are
		enabled
		1 = character sets defined by bit 1 and bit 2 are
		disabled and the "Yes/No" response is
		requested
	bits 4-7: = RFU
	bit 8:	0 = no help information available
		1 = help information available
<text>	String as prompt for text.
<iconQualifier>	Unsigned Integer, range 0 – 255, used as a bitfield.
	bit 1:	0 = icon is self explanatory and replaces text
		1 = icon is not self-explanatory and shall be
		displayed with the text
		Determined value only if associated icon id is
		not 0 (an icon exists).
	bits 2-8: = RFU
<iconId>	0-255, 0: no icon

ReferenceNote

Siemens

MC35_SAT_01_v02.00 Page 34 of 65 11.01.2002