Sierra Wireless AirCard 710, AirCard 750 manual Windows NT, Inserting the AirCard

Note: The AirCard driver requires that Windows Networking is installed. Also the PC Card slots must be enabled. If you are not certain that networking is installed and the slots enabled, see the Windows NT user documen- tation for instructions.

Your PC must be off whenever you insert or eject the AirCard

AirCard 750 only

Chapter 1: Introducing the AirCard 555 Network Card

Windows NT

Note: You must re-install the Windows NT Service Pack after you install the AirCard driver. Ensure you have your Service Pack CD before you begin. (Version 6a is supported.)

Note: Windows system files may also be required to complete the installation. These files are located on the Windows NT CD.

1. If the AirCard CD is not already in your CD-ROM drive,
insert it. The CD should auto-start and display a menu.
· If the CD does not auto-start, select Start > Run and enter
d:\launch.exe where d is the drive letter of your CD-ROM
drive.	PCs
2. From the CD start-up menu, select notebook installation and
	Notebook
3. Use the Next and Back buttons to navigate through the
documentation and then notebook software installation to
launch the InstallShield Wizard.
wizard.
Using the default settings for the Destination Location and
Program Folder is recommended unless you have special
requirements and an advanced understanding of PC con-
figuration.
On completion of the software installation, exit from the
startup menu by clicking exit in the lower right corner.

Inserting the AirCard

1.Close all Windows programs and turn your PC off.

2.Attach the antenna to the AirCard. (The AirCard 710 has a built-in antenna.)

Rev 1.2 Mar.02 15