Deutsch
English
Illustr. 8.2
Illustr. 8.0 | Illustr. 8.1 |
|
Then remove the installation frame from the device with the aid of the disassembly key, by sliding the disassembly keys into the provided openings on the right and left side of the device, as described in illustr. 8.1. Make sure that the protrusion on the disassembly key points away from the device during the insertion (illustr. 8.2). Afterwards, the frame can be slid down over the device towards the rear.
Now slide the installation frame into the installation slot provided for the car radio.
Now attach the installation frame by bending the installation brackets towards the outside with a screwdriver. The frame is properly installed when it can no longer be pulled out, yet also keeps from sliding into the installation slot.
Now connect the cable set and the antenna to the vehicle’s electronics corresponding to illustr. 8.3 and illustr. 8.4 as well as the table below. Also observe the specifications in sections 8.2 to 8.4.
14
