Entering the password recall procedure
1.Make sure the Input Password page displays on screen. Press and hold PICTURE MODE on the remote control for 3 seconds. The projector will display a coded number on the screen.
2.Write down the number and turn off your projector.
3.Seek help from the local service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector.
Recall Password
Please write down the recall code, and contact your nearest SIM2 Customer Center.
Recall code:
255 255 255 255
EXIT Back
Changing the password
1.Press MENU on the remote control and then press 
/ 
until the Setup menu is highlighted.
2.Press 
/
to highlight Password and press ENTER. The Password page displays.
3.Highlight Change Password and press ENTER. The Input Current Password page displays.
4.Enter the old password.
•If the password is correct, the message 'Input New Password' displays.
•If the password is incorrect, the password error message displays lasting for three seconds, and the message 'Input Current Password' displays for your retry. You can either press MENU to cancel the change or try another password.
5.Enter a new password.
IMPORTANT: The digits being input will display as asterisks
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6.Confirm the new password by
7.You have successfully assigned a new password to the projector. Remember to enter the new password next time the projector is started.
8.To leave the OSD menu, press MENU.
Disabling the password function
To disable password protection, go back to the Setup > Password > Password menu. Highlight Password and select Off by pressing 
/ 
. The message 'Input Password' displays. Enter the current password.
•If the password is correct, the OSD menu returns to the Password page with 'Off' shown in the row of Password. You will not have to enter the password next time when turning on the projector.
•If the password is incorrect, the password error message displays lasting for three seconds, and the message 'Input Password' displays for your retry. You can either press MENU to cancel the change or try another password.
Password Changed
Password
Password | On |
Change Password
EXIT Back
Note that though the password function is disabled, you need to keep the old password in hand should you ever need to
Using the projector 21
