Sim2 Multimedia D60 user manual Troubleshooting, Problem Cause Remedy

Troubleshooting

Problem	Cause	Remedy
		Plug the power cable into the AC inlet
		on the rear of the projector, and plug
	There is no power from the	the power cable into to the power
	power cable.	outlet. If the power outlet has a
		switch, make sure that it is switched
The projector does		on. (See page 18)
	The power switch is not in the	Put the power switch in the on
not turn on.	on position.	position. (See page 18)
	Attempting to turn the	Wait until the cooling down process
	projector on again during the
		has completed.
	cooling process.
	The lamp cover is not securely	Correctly attach the lamp cover. (See
	attached.	page 44)
	The video source is not turned	Turn the video source on and check
		that the signal cable is connected
	on or connected correctly.
		correctly. (See page 15)
No picture.	The projector is not correctly
	connected to the input source	Check the connection. (See page 15)
	device.
	The input signal has not been	Select the correct input signal with the
		Source buttons on the remote control.
	correctly selected.
		(See page 18)
	The connection cables are not	Correctly connect the cables to the
Image is unstable.	securely connected to the
		appropriate terminals. (See page 15)
	projector or the signal source.
	The projection lens is not	Adjust the focus of the lens using the
Picture is blurred.	correctly focused.	focus ring. (See page 19)
	The projector and the screen	Adjust the projection angle and
		direction as well as the height of this
	are not aligned properly.
		unit if necessary. (See page 22)
	The batteries are out of power.	Replace both of the batteries with
		new ones. (See page 5)
Remote control
	There is an obstacle between
does not work	the remote control and the	Remove the obstacle. (See page 5)
correctly	projector.
	You are too far away from the	Stand within 8 meters (26.2 feet) of the
	projector.	projector. (See page 5)

Additional information 47