SmartBridges sB3010 manual Data Encryption Configuration

i n t e l l i g e n t w i r e l e s s p l a t f o r m

3.Choose the Authentication as ‘Open System’ or ‘Shared Key’ by clicking on the radio button.

4.Choose a WEP Key Size (64 Bits or 128 Bits) from the pull-down list. WEP key length is 10 characters for 64 Bits and 26 characters for 128 Bits.

5.Choose a Valid Key from the pull-down list.

6.Enter the WEP key in the Key Table entries.

7.Click the ‘Apply Changes’ button to change the settings.

Note: The system will validate the key entries and provide error or warning notifications. User must enter the key indicated by the Valid Key selection.

Figure 2-32 Data Encryption Configuration

Follow the steps below to disable the Data Encryption:

1.Click the ‘Data Encryption’ link from the ‘Radio Main’ page.

2.If it is in Shared key mode, please set to Open System before you can click Disable

3.Click the ‘Disable’ button on the WEP.

4.Click the ‘Apply Changes’ button to change the settings.

Figure 2-33 Data Encryption Disable

airHaul™ Nexus User Guide Page 47 of 80