i n t e l l i g e n t | w i r e l e s s | p l a t f o r m |
The following page summarizes the page contents of the System Configuration page.
|
|
| Table |
|
|
|
|
| Page Item |
| Descriptions. |
|
|
|
|
| System Name |
| Displays name of airClient unit |
|
| Allows user to change airClient unit name | |
|
|
| |
| System Description |
| Displays description of airClient unit |
|
| Allows user to change airClient unit description | |
| SNMP Security |
| Access the SNMP security settings |
|
|
|
|
| Reset |
| Reset device |
| Reset To Factory |
| Reset device to factory defaults |
| Defaults |
| |
|
|
| |
| Delayed Reset |
| Schedule a reset |
|
|
|
|
| NTP Server |
| NTP server setup, as well as NTP time if server is setup |
|
|
|
|
| Software Version |
| Display the installed firmware version |
|
|
|
|
| Radio Firmware |
| Display the installed radio firmware version |
| Version |
| |
|
|
| |
| Edit Configuration |
| Provide links to edit IP, radio, configurations |
|
|
|
|
| Ethernet MTU Size |
| Set the Ethernet MTU Size |
| Syslog server IP |
| Display the current message Syslog server IP Address. |
| Address |
| User can change the IP address. |
| SNMP Trap IP |
| Display the current SNMP trap IP address. |
|
| User can change the IP address. | |
|
|
| |
| Log Level |
| Display the current Log Level |
|
|
|
|
|
|
| Suspends/Enables the radio defenders. |
|
|
| If the Watch Guard is Suspended the defenders will stop for 2 hours and start |
|
|
| again thereafter. |
| Watch Guard |
| If the Watch Guard is enabled the radio defender’s will start immediately. |
|
|
| |
|
|
| Note: The Radio Defenders will monitor the Wireless Association Status |
|
|
| (automatically) and traffic and take corrective action if needed. |
|
|
|
|
| LED Control |
| Display the current led on status. |
|
| User can change the LED status to on/off | |
|
|
| |
| Current |
| Display the current operational mode. |
| Operational mode |
| User can change the current operational mode. |
7.1.1. SNMP Security
The user can edit the SNMP Community String and SNMP Access filters. The SNMP community needs to match with the SNMP monitoring software used. The SNMP Access Filters allows you to determine which host(s) is authorized to monitor the device using SNMP. It is recommended that you set this for security reason and to prevent an attack. To change the SNMP security settings, click on the SNMP security link in the System Configuration page. Figure
airClient™ Nexus User Guide | Page 49 of 66 |
|
