EC Conformance Declaration Class a | SMC Networks SMC6724L3 INT

COMPLIANCES

EC Conformance Declaration - Class A

SMC contact for these products in Europe is:

SMC Networks Europe, Edificio Conata II,

Calle Fructuós Gelabert 6-8, 2o, 4a,

08970 - Sant Joan Despí, Barcelona, Spain.

This information technology equipment complies with the requirements of the Council Directive 89/336/EEC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility and 73/23/EEC for electrical equipment used within certain voltage limits and the Amendment Directive 93/68/EEC. For the evaluation of the compliance with these Directives, the following standards were applied:

RFI Emission:	• Limit class A according to EN 55022:1998
	• Limit class A for harmonic current emission according to
	EN 61000-3-2/1995
	• Limitation of voltage fluctuation and flicker in low-voltage supply
	system according to EN 61000-3-3/1995
Immunity:	• Product family standard according to EN 55024:1998
	• Electrostatic Discharge according to EN 61000-4-2:1995
	(Contact Discharge: ±4 kV, Air Discharge: ±8 kV)
	• Radio-frequency electromagnetic field according to EN 61000-4-3:1996
	(80 - 1000 MHz with 1 kHz AM 80% Modulation: 3 V/m)
	• Electrical fast transient/burst according to EN 61000-4-4:1995 (AC/
	DC power supply: ±1 kV, Data/Signal lines: ±0.5 kV)
	• Surge immunity test according to EN 61000-4-5:1995
	(AC/DC Line to Line: ±1 kV, AC/DC Line to Earth: ±2 kV)
	• Immunity to conducted disturbances, Induced by radio-frequency
	fields: EN 61000-4-6:1996 (0.15 - 80 MHz with
	1 kHz AM 80% Modulation: 3 V/m)
	• Power frequency magnetic field immunity test according to
	EN 61000-4-8:1993 (1 A/m at frequency 50 Hz)
	• Voltage dips, short interruptions and voltage variations immunity test
	according to EN 61000-4-11:1994 (>95% Reduction @10 ms, 30%
	Reduction @500 ms, >95% Reduction @5000 ms)
LVD:	• EN 60950 (A1/1992; A2/1993; A3/1993; A4/1995; A11/1997)

Warning: Do not plug a phone jack connector in the RJ-45 port. This may damage this device. Les raccordeurs ne sont pas utilisé pour le systéme téléphonique!

iv

Image 8

SMC Networks SMC6724L3 INT manual EC Conformance Declaration Class a

Contents

TigerSwitch 10/100 Page TigerSwitch 10/100 Installation Guide Trademarks Limited Warranty SMC Networks, Inc Tesla Irvine, CA Industry Canada Class a CompliancesFCC Class a EC Conformance Declaration Class a Japan Vcci Class a Australia AS/NZS 3548 1995 Class a Underwriters Laboratories Compliance Statement Safety ComplianceWarnhinweis Faseroptikanschlüsse Optische Sicherheit Wichtige Sicherheitshinweise Germany Viii Table of Contents Installing the Switch Making Network Connections Appendices Table of Contents Chapter About Tigerswitch 10/100 Overview Switch Architecture SMC6724L3 Front and Rear Panels Management Options Description of Hardware RJ-45 Ports Ports Status LEDs Port Status LEDs System Status LEDs System Status LEDs Optional 100BASE-FX Module SMC6824FSSC Optional Media Extender ModulesOptional 10/100/1000BASE-T Module SMC6824GT Optional 100BASE-FX Module SMC6824FMSC Optional 1000BASE-X Gbic Module SMC6824GB Optional Redundant Power Unit Power Supply Receptacle Expandability Features and BenefitsConnectivity Performance Management About the Tigerswitch 10/100 Introduction to Switching Chapter Network Planning Application Examples Collapsed Backbone Central Wiring Closet Central Wiring Closet Remote Connection with Fiber Cable Remote Connection with Fiber Cable Making Vlan Connections Making Vlan Connections Using Layer 3 Routing IP Routing for Unicast Traffic Connectivity Rules Mbps Gigabit Ethernet Collision Domain 10/100 Mbps Ethernet Collision Domain Application Notes Network Planning Installing the Switch Selecting a Site Optional Rack-Mounting Equipment Equipment ChecklistPackage Contents Mounting Rack Mounting Attaching the Brackets Desktop or Shelf Mounting Attaching the Adhesive Feet Installing an Optional Module into the Switch Installing an Optional Module Installing a Gbic Transceiver Installing a Gbic Transceiver Connecting to a Power Source Power Receptacle Connecting Network Devices Chapter Making Network ConnectionsTwisted-Pair Devices Cabling Guidelines Connecting to PCs, Servers, Hubs and Switches Making Twisted-Pair Connections TWISTED-PAIR Devices Wiring Closet Connections Wiring Closet Connections Fiber Optic Devices Making SC Port Connections Appendix a Troubleshooting Diagnosing Switch Indicators In-Band Access Power and Cooling ProblemsInstallation Specifications Appendix B Cables Twisted-Pair Cable and Pin Assignments Fiber SMF Figure B-1. RJ-45 Connector Pin Numbers 10BASE-T/100BASE-TX Pin Assignments Straight-Through Wiring Crossover Wiring 1000BASE-T Pin Assignments 1000BASE-T Cable Requirements Cable Testing for Existing Category 5 CableAdjusting Existing Category 5 Cabling Wiring Map for Serial Cable Console Port Pin Assignments Cables Base Unit Appendix C SpecificationsPhysical Characteristics Compliances 100BASE-FX Extender Modules WarrantySlide-in Modules 1000BASE-T Extender Module Model 1000BASE-X Gbic Module Specifications Appendix D Ordering Information Ordering Information Glossary 1000BASE-T Auto-Negotiation BandwidthCollision Collision Domain Fast Ethernet Switch Fast EthernetFull Duplex Gigabit Ethernet Media Access Control MAC Ieee 802.3zLAN Segment Link Segment Straight-through Port RJ-45 ConnectorSwitched Ports Glossary-6 Index Numerics Index-2 Index-3 Index-4 Page For Technical SUPPORT, Call