SMC Networks SMC7404BRA EU manual Connect the ADSL Line, Phone Line Configuration

INSTALLATION

Connect the ADSL Line

Run standard telephone cable from the wall jack providing ADSL service to the WAN port on your Barricade. When inserting an ADSL RJ-11 plug, be sure the tab on the plug clicks into position to ensure that it is properly seated. If you are using splitterless ADSL service, be sure you add low-pass filters between the ADSL wall jack and your telephones. (These filters pass voice signals through but filter data signals out.)

Phone Line Configuration

Installing a Full-rate Connection

If you are using a full-rate (G.dmt) connection, your service provider will attach the outside ADSL line to a data/voice splitter. In this case you can connect your phones and computer directly to the splitter as shown below:

Plain Old

Telephone

System (POTS)

Residential

Connection

Point (NID)

Voice

Splitter

Data

ADSL Router

or

Ethernet

hub or switch

Figure 2-1. Installing With a Splitter

2-6