SMC Networks TigerSwitch manual Lacp system-priority, 168

COMMAND LINE INTERFACE

Example

The following shows LACP enabled on ports 11-13. Because LACP has also been enabled on the ports at the other end of the links, the show interfaces status port-channel 1 command shows that Trunk 1 has been established.

Console(config)#interface	ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface	ethernet 1/12
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface	ethernet 1/13
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#exit
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:	100TX
Mac address:	00-00-e8-00-00-0b
Configuration:
Name:
Port admin:	Up
Speed-duplex:	Auto
Capabilities:	10half, 10full, 100half, 100full
Flow control status:	Disabled
Port security:	Disabled
Max MAC count:	0
Current status:
Created by:	LACP
Link status:	Up
Operation speed-duplex:	100full
Flow control type:	None

Member Ports: Eth1/11, Eth1/12, Eth1/13,

Console#

lacp system-priority

This command configures a port's LACP system priority. Use the no form to restore the default setting.

Syntax

lacp {actor partner} system-priority priority no lacp {actor partner} system-priority

•actor - The local side an aggregate link.

•partner - The remote side of an aggregate link.

4-168